Descargar Imprimir esta página

Gude GH 2000 K Traducción Del Manual Original página 21

Termo ventilador cerámico

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 39
Troubleshooting
Problem
Cause
Unit does not have
power supply
Unit, mains cable
or mains plug is
defective
The room tempe-
rature is above the
temperature set on
the thermostat.
Unit without
function/not
heating
No heating level set
The safety thermo-
stat has tripped
The overheating
protection has been
triggered
Reduced air
Air inlet and outlet
flow
not free
Note
After all troubleshooting, maintenance and cleaning
work, wait at least 5 minutes before switching the unit
on again.
If the unit still does not work properly, please contact
the customer service or an authorised electrician. The
unit must then be checked and repaired if necessary.
Cleaning & Maintenance
Hot surface warning
Solution
Warning of electrical voltage
Check the socket
Before cleaning, always switch off the appliance,
Plug in the mains
disconnect the mains plug and allow the appliance to
plug correctly
cool down.
Check the house
Never place/immerse the appliance in water for
fuse
cleaning as this could result in electric shock or fire.
Contact customer
Never touch the mains plug with wet or damp hands.
service or a spe-
Remove dust from the unit with a dry cloth.
cialist
A slightly damp cloth can be used to remove stains.
Warning of electrical voltage
Increase the ther-
Work on electrical components may only be carried
mostat tempe-
out by an authorised specialist company.
rature
Repairs and work not described in these instructions
should only be carried out by qualified personnel.
Only use original accessories and original spare parts.
Adjust the heat
Always keep the appliance clean, especially the
level
ventilation slots.
Switch off the unit
Repairs that require opening the unit are reserved
and disconnect the
exclusively for the manufacturer or its customer
mains plug.
service.
Eliminate the cause
of overheating
before restarting
Storage
the appliance.
Switch off the unit
Hot surface warning
and disconnect the
Before storage, always unplug the mains cable from
mains plug.
the socket by grasping it by the mains plug.
Contact customer
service or a spe-
Switch off the unit and let it cool down before storing.
cialist
Clean the unit (see chapter Cleaning) and store it in the
original packaging.
Clean and observe
minimum distances
Store the appliance in a well-ventilated and dry place
out of the reach of children.
Store the unit protected from heat, frost, direct sun-
light and dust.
Store the unit in an upright position.
ENGLISH
21

Publicidad

loading

Este manual también es adecuado para:

85178