Craftsman 919-15309-CA Manual Del Propietário página 15

3. Plug the power cord into the cor-
rect branch circuit receptacle.
(Refer to Voltage and Circuit
Protection paragraph in the
Installation section of this manual.)
4. Attach hose and accessories.
Risk of unsafe
operation. Do not
use damaged or worn accessories.
Risk of Bursting.
Too much air
pressure causes a hazardous risk of
bursting. Check the manufacturer's
maximum pressure rating for air
tools and accessories. The regulator
outlet pressure must never exceed
the maximum pressure rating.
CUSTOMER RESPONSIBILITIES
Check Safety Valve
Drain Tank
Remove tank from service
- For more information, contact a Trained Service Technician
1
Risk of Unsafe
Operation. Unit
cycles automatically when power is
on. When performing maintenance,
you may be exposed to voltage
sources, compressed air or moving
parts. Personal injuries can occur.
Before performing any maintenance
or repair, disconnect power source
from the compressor and bleed off
all air pressure.
NOTE: See Operation section for the
location of controls.
Compressed air from the unit may
contain water condensation and
oil mist. Do not spray unfiltered air
at an item that could be damaged
by moisture. Some air tools and
accessories may require filtered
air. Read the instructions for the air
tools and accessories.
How to Start
1. Turn the Off/Auto switch to
"AUTO" and allow tank pressure
to build. Motor will stop when
tank pressure reaches "cut-out"
pressure.
2. Turn the regulator knob clock-
wise until desired pressure is
reached.
The compressor is ready for use.
MAINTENANCE
Before Daily or
each after each
use use
•
•
TO CHECk SAFETY VALVE
does not work properly, over-
pressurization may occur, causing
air tank rupture or an explosion.
wear certified safety equipment:
ANSI Z87.1 eye protection (CAN/CSA
Z94.3) with side shields.
Before starting compressor, pull the
ring on the safety valve to make sure
that the safety valve operates freely.
If the valve is stuck or does not oper-
ate smoothly, contact a trained service
technician.
15 - ENG
Risk of unsafe
operation.
See tank
warning label
• (1)
Risk of Bursting.
If the safety valve
Risk from Flying
Objects. Always