IMPORTANT
Please read the assembly instructions carefully before you start to assemble this greenhouse and
follow the instructions step by step. Keep the instruction in a safe place for future reference.
SAFETY ADVICE
Allow at least a half a day to assemble the greenhouse by 2-3 persons.
4
Do not attempt to assemble the greenhouse in windy or wet conditions.
4
Wearing work gloves, shoes, long sleeves and safety goggles during assembly.
4
Do not attempt to assemble this greenhouse if you are tired, have taken drugs or alcohol or if you are prone to dizzy
4
spells or distracted from the job at hand.
Maintain a safe working environment. Make sure there's adequate surrounding workspace. Keep the work area
4
tidy (free of obstructions, grease, oil, trash and other debris).
Keep children and pets away from the assembly area.
4
If using a step ladder or power tools ensure that you follow the manufacturer's safety advice.
4
Do not lean against or push the greenhouse during construction.
4
Dispose of all plastic bags. Keep them out of reach of small children.
4
Hot items such as recently used grills, blowtorches etc. must not be stored in the greenhouse.
4
This product is designed to be used mainly as a greenhouse.
4
SELECTING A SITE
Make sure the greenhouse is located on a flat, level surface. Choose a sunny position away from overhanging trees. Do
not position the greenhouse in an area exposed to excessive wind.
ASSEMBLY ADVICE
Before you start, separate and identify all the parts against the parts list. Keep all small parts (screws etc.) in a
4
bowl so they do not get lost.
The UV-protected side of the panel is covered with opal white film and must face towards the sun. Use a marker to
4
place a small "x" on the bottom corner of each face to signify UV coated side. Remove approximately 5 cm of film
from all sheet edges before installing. Removing all film immediately after the construction is completed.
Tighten all screws once assembly is completed. Please note: Anchoring the greenhouse to the ground is essential
4
to its stability and rigidity.
MAINTENANCE
When your greenhouse needs to be cleaned, use a mild detergent solution and rinse with cold clean water.
4
Keep the door tracks clear of dirt and other stuff that prevent them from sliding easily.
4
In areas where there's snow, we recommend the following to protect the greenhouse :
4
Support the ridge at the center of the greenhouse
→
Silicone all panels
→
Remove snow loads timely
→
3
EN