Publicidad
Idiomas disponibles
Idiomas disponibles
Note
You can use the device either with the supplied mains adapter or with batteries. We recommend using the
mains adaptor for reasons of sustainability.
8. Initial use with batteries
1. Open the battery compartment on the rear of the hand switch.
2. Insert four 1.5V AA (alkaline type LR06) batteries. Make sure that the batteries are inserted the correct way
round. See the graphic in the battery compartment. Do not use rechargeable batteries.
3. Close the battery compartment on the rear of the hand switch until you see and hear it click into place.
8.1 Initial use with mains part
Note
Before using for the first time with the mains part, check there
are no batteries fitted in the hand switch.
1. Connect the mains part to the hand switch as shown.
2. Plug the other end of the mains part into a suitable socket.
3. The device is now ready for use.
9. Use
9.1 Starting treatment
IMPORTANT:
• Avoid undoing the cuff hook-and-loop fastener during use as this could impair the functionality of the device.
Only open the cuff hook-and-loop fastener if the pressure on your legs becomes uncomfortable during use
or press the stop button.
• Make sure the air hoses do not become kinked during use.
• Do not cover the cuffs with a blanket or other objects during use.
1. Always follow the instructions in the "Initial use" section.
2. Place the leg and thigh cuffs one at a time secure-
ly over your thighs, lower legs and feet as shown;
have your legs bare or wear closely fitting clothing
(e.g. tights).
The cuffs should be fastened so that two fingers
can still fit under the cuffs. If the cuffs feel too
tight, fasten the cuffs so that you can get your flat
hand under them.
IMPORTANT:
If you are using the lower-leg cuffs only, you do not
need to put on the thigh cuffs.
21
Publicidad
