Publicidad
Idiomas disponibles
Idiomas disponibles
Water supply
Caution! Impurities in the intake water damage the
pump. To prevent this we expressly urge you to use
the Kärcher water filter (order no. 4.730-059).
The operation of the high-pressure cleaner with a
closed water supply line causes damage to the cy-
linder head unit. Please never operate the high-pres-
sure cleaner with a closed water supply tap.
The unit can either be supplied from the water main
or from water in an open container.
Water supply from the water main
• Connect a supply hose (not included) to the water
inlet of the unit and to the water supply (e.g. water
tap).
• Open the water supply.
Water supply from an open container
• Unscrew the coupling part for the water inlet.
• Screw the suction hose with filter (not included,
see "Special accessories") onto the water connection
of the unit.
• Hang the filter in the container.
• Vent the unit before operation.
– Unscrew the high-pressure line at the high-pres-
sure outlet of the unit.
– Switch on the unit and let it run until water free
of bubbles emerges at the high-pressure out-
let.
– Switch off the unit and screw on the high-pres-
sure hose again.
Preparation
• Insert power plug.
• Turn master switch to "I".
Switching on
• Press safety button on the handgun and pull the
lever.
Switching off
• Release the lever.
During breaks in work and when leaving the unit secure
it against inadvertent switching on by pressing the
safety button.
Adding the cleaning agent
• Remove spray lance
No detergent in high-pressure mode
• Suspend the filter of the detergent suction hose in
detergent reservoir.
After cleaning agent has been added:
• Suspend the filter of the detergent suction hose in
a container of clear water, switch on the unit for
about one minute and flush through.
Recommended cleaning method
1. Spray the cleaning agent on the dry surface spa-
ringly and let it react (but not dry out).
2. Wash off the loosened dirt with the high-pressu-
re jet.
Connect accessories
Depending on the model the following accessories
are either included in the scope of delivery or are
obtainable from specialist dealers (see also "Speci-
al accessories").
• Exchange the respective accessory with the spray
lance.
Wash brush
for large, smooth surfaces – e.g. on the automobile,
caravan or boat.Cleaning agent can be added.
Rotating wash brush
for gentle and thorough cleaning – e.g. bodywork
and glass surfaces.
Cleaning agent can be added.
Rotary nozzle
for stubborn accumulations of grime – e.g. moss-
covered promenade tiles or facades.
Work without cleaning agent and with the highest
operating pressure.
Finishing operations
• Master switch to "0".
• Draw out power plug.
Water supplied from the water main
• Close the water supply tap.
• Separate the unit from the water connection.
Water supplied from an open container
• Unscrew the suction hose with filter at the water
inlet of the unit.
• Pull the lever on the handgun until the unit is wit-
hout pressure.
• Press in the safety button to protect the unit against
inadvertent switching on.
Safekeeping
Caution! Frost can destroy an incompletely emp-
tied unit. In the winter keep the unit in a frost-free
room.
• Separate the spray lance from the handgun.
• Wind up the power cord and, for example, hang it
around the handgun.
English - 19
Publicidad
