Publicidad
Idiomas disponibles
Idiomas disponibles
Turning the appliance on
Cooling and
Dehumidification
mode
21
22
Only
dehumidification
Plug the appliance into the mains electricity
supply.
Turn the appliance on using the "On/Off" button.
Select either the "Maximum cooling"
"Silent cooling"
Fig. 21.
Set the thermostat to the desired temperature with
buttons
and
The appliance cools and dehumidifies the air in
the room at the same time in order to produce
pleasant air conditions.
Should the appliance turn itself off by effect of
the thermostat, it will come back on again when
room temperature rises 2°C.
The water produced during this process by
condensation is led outside and released from
the condenser by evaporation.
If the red warning light comes on:
Condensed water has unduly accumulated in the
tank on the indoor unit.
Condensed water is emptied using the flexible
drainage pipe, which is coupled onto the water
drainage nozzle on the bottom of the appliance,
(see description of your appliance, page
Fig. 23.
Make sure that the flexible duct which joins the
two units has not been squashed or been
trapped in any way. The difference in height
between the two units should not exceed 1.5 m.
Fig. 7.
Set the function at this setting, the appliance will
only reduce the humidity present in the
atmosphere, without affecting the temperature. The
appliance is capable of extracting up to 60 litres of
water a day from the air depending on atmospheric
conditions.
Release the water from the outdoor unit by
removing the plug from the lower tray.
option, via the "mode" button,
, Fig. 22.
or the
26).
35
Publicidad
