Publicidad
Idiomas disponibles
Idiomas disponibles
Inserting/removing the battery pack
Attaching the battery pack
♦
Push the rotation direction switch
middle position (lock). Push the battery pack
into the handle until it clicks into place.
Removing the battery pack
♦
Press the release button
battery pack
.
Checking the battery charge level
♦
Press the battery charge level button
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Fitting the belt clip
♦
Loosen the fixing screw
Phillips screwdriver (not supplied).
♦
Hold the corresponding hole of the belt clip
over that of the screw thread.
♦
Tighten the fixing screw
Switching on/off
Turn on
♦
Press and hold the ON/OFF switch
start up the tool.
The LED work light
ON/OFF switch
This provides illumination of the work area in
poor lighting conditions.
Switching off
♦
Release the ON/OFF switch
the appliance.
8
GB │ IE
■
│
into the
and remove the
to
as follows:
using a standard
3a
.
3a
to
lights up when the
is pressed lightly or fully.
to switch off
Setting/preselecting the rotation
speed/tightening torque
♦
Press the torque selector
required torque in stages. The selected torque is
shown on the torque display
♦
Press the ON/OFF switch
speed and a low tightening torque. Increasing
the pressure increases the speed and the tight-
ening torque.
■
The tightening torque depends on the selected
speed/torque selection and impact duration.
NOTE
►
When tightening wheel nuts, however, the
smallest torque setting must be selected to
avoid over-tightening.
►
The integrated motor brake ensures that the
tool stops quickly.
ATTENTION!
♦
The tightening torque actually attained must
always be checked with a torque wrench!
Changing the direction of rotation
♦
Change the direction of rotation by pressing the
rotation direction switch
right.
Fitting a socket
♦
Push one of the supplied sockets
adapter
onto the tool holder
Maintenance and cleaning
WARNING! RISK OF INJURY!
Always switch the appliance off and
remove the battery before carrying
out any work on the appliance.
The tool is maintenance-free.
■
The appliance must always be kept clean, dry
and free from oil or grease.
■
Never allow liquids to get into the tool.
to select the
.
lightly for a low
towards the left or
or the
.
PASSP 20-Li A3
Publicidad
