Kenwood KVL65 Instrucciones página 13

To Fit And Use Your
Splashguard
Refer to Illustrations
1 Raise the mixer head until it locks.
2 Fit the bowl onto the base.
3 Push the splashguard onto the
underside of the mixer head until fully
located. The hinged section should be
positioned as shown.
4 Insert required tool.
5 Lower the mixer head.
During mixing, ingredients can be
added directly to the bowl via the
hinged section of the splashguard.
You do not need to remove the
splashguard to change tools.
6 Remove the splashguard by raising
the mixer head and pushing it down.
Tool Adjustment
Refer to Illustrations
K-beater & Whisk
The tools are set to the correct height
for the bowl supplied in the factory and
should not require adjustment.
However, if you wish to adjust the tool
use a suitable sized spanner:
TYPE KVC65 = 15mm
TYPE KVL65 = 19mm
Then follow the instructions below:
1 Unplug the appliance.
2 Raise the mixer head and insert the
whisk or beater.
3 Lower the mixer head. If the
clearance needs to be adjusted,
raise the mixer head and remove the
tool. Ideally the whisk and K-beater
should be almost touching the
bottom of the bowl.
4 Using a suitable spanner loosen the
nut sufficiently to allow adjustment
of the shaft. To lower the tool closer
to the bottom of the bowl, turn the
shaft anti-clockwise. To raise the tool
away from the bottom of the bowl
turn the shaft clockwise.
M N
–
O
5 Re-tighten the nut.
6 Fit the tool to the mixer and lower
the mixer head. (Check its position
see points above).
7 Repeat the above steps as necessary
until the tool is set correctly. Once
this is acheived tighten the nut
securely.
Note: Spanner shown is for
illustration purpose only.
Dough Tool
This tool is set at the factory and should
require no adjustment.
To Fit and Remove Head
Cover
Refer to Illustrations
1 Remove the slow speed and high
speed outlet covers.
2 With the retention clip pressed in, lift
up the head cover and slide forward.
3 To fit an alternative head cover, insert
the pegs on the end of the head cap
into the two holes on the slow speed
outlet.
4 Whilst pressing the retention clip,
push the head cover down into place
on the mixer head.
5 Replace slow speed and high speed
outlet covers.
Care & Cleaning
Always switch off and unplug before
cleaning.
A little grease may appear at the
slow speed outlet
use it. This is normal – just wipe it off.
Power Unit, Outlet Covers and Head
Cover
Wipe with a damp cloth, then dry.
Never use abrasives or immerse in
water.
9
P U
–
when you first