Adjustments - Ryobi DP103L Manual Del Operador

WARNING:
Before performing any adjustment, make sure the tool
is unplugged from the power supply and the switch is in
the OFF ( O ) position. Failure to heed this warning could
result in serious personal injury.
ADJUSTING TABLE HEIGHT
See Figure 19, page 20.
 Hold the table with one hand and loosen the table lock
handle.
 Rotate the table adjustment handle clockwise to raise the
table.
 Rotate the table adjustment handle counterclockwise to
lower the table.
 Position the table to the desired height and retighten the
table lock handle.
ADJUSTING TABLE BEVEL
See Figures 20 - 21, pages 20 and 21.
The drill press is equipped with a tilting table that allows
you to drill angled holes. The table can be tilted left or right,
from 0º to 45º.
To tilt the table:
 Loosen the large hex bolt located underneath the table. 3050
2200
3050
 Use the bevel scale to tilt the table to the desired angle.
 Retighten the hex bolt securely.
1575
2200
ADJUSTING DEPTH GAUGE
930
See Figure 21, page 21.
1575
Adjust the depth gauge when you need to drill a number of
holes to exactly the same depth.
630
930
 Loosen the depth stop locking collar.
 Rotate depth gauge to desired setting.
 Retighten depth stop locking collar, if needed.
CHANGING SPEEDS
See Figures 22 - 24, page 21.
The spindle speed is determined by the location of the belt
on the pulleys inside the head assembly. The speed chart
located on the cover inside the head assembly shows the
recommended speed and pulley configuration for each drill-
ing operation.

ADJUSTMENTS

NOTE: The pivot bolts located on the side of the tool should
allow the motor to move freely once the tension bolt is loos-
ened. If the motor is difficult to move, it may be necessary
to loosen the pivot bolts slightly (1/4 turn). Do not retighten.
To change the pulley configuration:
 Lift head assembly cover from side to open.
 Loosen the tension bolt until there is enough slack in the
belt for it to be repositioned around the pulleys.
 Reposition the belt according to the speed chart.
• When decreasing speed, move the belt down the
motor pulley first and then down the spindle pulley.
• When increasing speed, move the belt up the spindle
pulley first and then up the motor pulley.
 Turn the belt by hand until you are certain it is properly
aligned on the grooves of the pulleys.
 Move the motor away from the tool until there is tension
in the belt.
 Hold the motor in place and retighten the tension bolt.
DRILL BIT DIAMETER (in.)
DIAMÈTRE DE LA FORET (po.)
DIÁMETRO DE LA BROCA (pulg.)
1/16 in.
1/8 in.
3/16 in.
1/4 in.
5/16 in.
3/8 in.
1/2 in.
13 - English
(1,6 mm)
(3,2 mm)
3050
(4,8 mm)
(6,3 mm)
(8,0 mm)
(9,5 mm)
2200
(12,7 mm)
3050
2200
3050
1575
2200
930
1575
630
930