Panasonic NC-ZA1 Instrucciones De Funcionamiento página 36

How to Clean
Dispenser:
Clean the dispensing spouts weekly or if used intensively, clean it frequently.
Clean the dispenser from the inside and outside with warm water and a suitable
brush to remove any residue and prevent mould from forming.
<To remove>
1
Press the left side of the door
with the dispenser to open.
(P. GB11)
2
Press the dispenser upwards.
Pull the distribution hose
lightly from the inner side of
the door and pressing to the
left so that it clicks out of the
fastener. Then remove the
dispenser.



Cleaning when spout is clogged
1
Disassemble the dispenser. Grip and pull the loose hose end near to the
spring and pull both hose ends with the sleeve ends out of the spout.
2
Pull the sleeves out of hoses  and disconnect the hoses from the
connecting piece  . Pull the hose and spring together from connecting
piece  .
3
Leave the parts immersed in a milk system cleaner for several hours.
Refer to the instructions on the milk system cleaner for the exact
quantity. Then rinse them thoroughly with clean water.
4
To assemble, insert both sleeve ends and hoses back together. Insert
both sleeve ends into the small spouts 1 and press them in until they
snap in properly. Push the connecting piece into the fixing slot 2 . Then
push the hoses to the right and left under the frame 3 .
Note
• If sleeves are inserted into large spouts, coffee is not dispensed
straight.
GB36
(Continued)
<To attach>
1
Place the dispenser in the upper position
back into the door and push it slightly
and slide it down until top of door high.
2
Pull the hose from inner side of the door opening and press it to
the right into the holder and push the funnel-shaped part of the
hose back into the collar until it fits perfectly.

3
Make sure top of the door and dispenser are same high, and
close the door firmly.
Dispenser
Collar
Correct Incorrect


Holder
  






