Publicidad
Idiomas disponibles
Idiomas disponibles
In this way, a variety of transmission modes are possible, from one transmitter to one receiver (point-to-
point) or from one transmitter to many receivers (point-to-multipoint) or from many transmitters to many
receivers (multipoint-to-multipoint) with software-controllable video wall integration.
An additional benefit of packet data transmission is that each type of signal (video, audio, RS232, etc.) is
independently routed and not necessarily to the same destination. For example, HDMI video from a particular
transmitter is routed to 4 receivers, while audio is sent to all receivers in the configuration.
This unlimited scalable and independent signal routing allows multiple scalable applications, including signal
extension, splitting, switching, matrix creation, and video wall functionality.
SYSTEM DIAGRAM
The following diagram illustrates the typical input and output connections that can be done:
-
IMPORTANT: to switch over a 10GbE switch, you must use a 10 GbE Layer 2 and Layer 3 switch with
IGMP snooping. Ensure that the IGMP snooping configuration is enabled and the broadcast
configuration is disabled using the appropriate configuration software provided by the switch
manufacturer.
-
The following table shows a list of switches verified to work with the HDMI-IP1800 system:
(* recommended)
HARDWARE CONFIGURATION
Follow the steps below to complete the system installation:
1.- Connect the power supply (12 V DC) to the power connectors.
2.- Connect the video source device to the HDMI input connector on each TX unit.
3.- Connect the video display device to the HDMI output connector on each RX unit.
Make
BlackBox
LGB5028A
Netgear
ProSAFE PLUS XS708E
Netgear
ProSAFE Smart XS708T/712T/716T/728T/748T
*Netgear
M4300 Series
Netgear
M7300-24XF XSM7224S
Speed-NT
UK-6000 Series
Extreme Network
Summit X670 Series
Arista Networks
7050X Series
Model
- 5 -
EN
EN
Publicidad
