Nash Siren R3+ Guia Del Usuario página 6

R3+ RECEIVER
Insert Battery:
Open battery compartment using crosshead screwdriver
and insert 1 x CR123A 3V battery (not supplied).
Ensure polarity is correct when fitting batteries:
• Positive battery terminal to positive receiver terminal
• Negative battery terminal to negative receiver terminal
To Turn R3+ Receiver On/Off:
Press and hold Power button for 2 seconds.
When turned on LEDs light sequentially green from left to
right with a sequence of increasing pitch bleeps and the
handset vibrates.
When turned off LEDs light red sequentially from right to
left with a sequence of decreasing pitch bleeps.
Tone: The R3+ Receiver replicates the tone of each R3+
head it is programmed to.
LED Colour:
The R3+ Receiver replicates the LED colour of each R3+
head it is paired with.
Volume:
Short press of the Volume button. Four volume settings
are available. Each consecutive short press of the Volume
button changes volume output by one level. The Volume
you hear represents the Volume being set.
Recall Last Event:
Short press of the Power button. This allows you to
check which alarm registered an indication even if you
missed the illuminated LED on the R3+ Receiver and
R3+ head. The LED that corresponds to the R3+ alarm
that last registered an indication will light and pulse for
ten seconds.
Vibrating Alert and Receiver Mute options:
Press and hold V button for 2 seconds. Each long press
scrolls through the four modes available.
6
Plus Instruction Manual.indd 6 Plus Instruction Manual.indd 6 28/07/2022 08:5 28/07/2022 08:5