Vortice 12101 Manual De Instrucciones página 35

ENGLISH
11. Connect the remote HMI.
12. Re-power the machine.
13. Wait about 30 sec – 1 minute: the symbol LED
14. The machine will resume normal operation at the end of the process.
15. Enter into the USE MENU with password 23 from the remote HMI display.
16. Change parameter "MBUD ID" so that it is different from 1 and different from that of the local display on-board the
machine: for example, enter the number 3 and press
17. End
Holiday
Special mode of operation: manually enabled and useful if the user leaves the room for a longer period of time.
Operation includes:
- fixed "30% less than the Minimum " speed (no other speeds, no OFF equipment);
- environment sensors not enabled (remote inputs not actived);
- bypass always closed.
NOTE: Activating the Mode "Holiday" will be deactivate other product functionings/selections. To re-activate other product
functionings/selections, need to deactivate the Mode "Holiday" before. For more details on how to activate / deactivate the
function, see "Activating / deactivating Holiday" in the "Control panel functions".
Post-ventilation
This kind of function is automatically activate after:
- every time Pre-Heater is turned off (if Pre-Heater installed)
- every time you turn the Appliance off
This is a normal system procedure and should not be perceived as a malfunction.
Program
Special mode of operation: manually enabled and allows the user to program weekly air speeds. In fact, it allows you to
assign up to 6 time bands with different speeds, including stopping the equipment. When the function is active, the
message "Progr." Appears on the display: see "Home Page" in the "Control panel functions" section. However, the speeds
can be manually changed even at specified intervals: in this case the word "Prg" will flash for 30 minutes and after it will go
back to the setted speed of the weekly time band. If in this 30 min any other function will change the speed, this 30 min
timer will go back to 0.
For more details on setting the time slots and dates, see "PRG Crono" in the "Control panel functions" section. For details
on how to activate / deactivate the function, see "Activating / deactivating Program" in the "Control panel functions" sec-
tion.
will flash on the remote display
both motor-fans active (about 3 minutes) to avoid
overheating;
indoor air is extracted at the max speed (about 2 minu
tes) to avoid condensate presence on the heat exchan
ger.
35