AEG D-VL 5666 Instrucciones De Servicio página 27

a) Wooden ceiling/beam: Attach the mounting bar us-
ing both long screws (M5*50) and the corresponding
washers and retainer rings.
b) Concrete ceiling: Mark the two positions in the slot-
ted holes using a pencil. Drill the installation holes for
the dowels. Insert the dowels into the holes. Attach
the mounting bar using both long screws (M5*50)
and the corresponding washers and retainer rings.
NOTE:
Use special caution when installing the fan to a con-
crete ceiling. In order to facilitate a secure installation,
stronger screws and dowels than those provided might
be neccessary.
4. Connect the electrical wires from the ceiling to the termi-
nal strip in the mounting bar.
Color of electrical wire
Brown or black (phase)
Blue (neutral)
Green yellow
(protective ground)
5. Remove the pre-installed screws and spring washers (3)
from the motor housing (11).
6. Attach the fan blades (9) to the motor housing using the 6
screws and 6 spring washers removed earlier. Important!
Do not remove the paper padding (4) underneath.
7. Connect the cable harness from the motor housing to
the mounting bar.
NOTE: In order to facilitate installation:
You may attach one screw hole of the baldachin to the
hook on the mounting bar.
Cleaning and maintenance
WARNING:
• Always switch off the respective home circuit breaker before car-
rying out any cleaning or maintenance work.
• Always wait until the fan blades have come to a complete stop.
• Make sure no liquid enters the electrical connections, as this
could otherwise cause electrical shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
Connection to
L
N
(Ground)
8. Attach the fan by remounting the baldachin to the
mounting bar. Make sure the pin of the baldachin is
aligned with the notch on the black cap of the spacer
tube. Tighten the four screws on the mounting bar.
9. Fit the pull chain extension (8).
10. Remove the paper cover from the spacer tube.
Operation
Fan
Use the switch (10) on the motor housing to set the rotation
direction of the fan blades. (Summer/winter operation)
CAUTION:
Only adjust the direction when the fan blades stand still.
Otherwise the motor could be damaged.
• Summer operation: Set the switch to "
• Winter operation: Set the switch to "
NOTE:
Winter operation might be without any result depending
on the size of the room.
Repeatedly pull the pull chain (5) on the motor housing to set
the speed of the fan blades.
1x = high speed
2x = medium speed
3x = low speed
4x = Fan is turned off.
• Clean the external surface of the fan with a slightly damp
cloth.
• Dry the fan with a dry, soft cloth.
English
27
" position.
" position.