Troubleshooting - Ryobi SC165VS Manual Del Operador

PROBLEM
Motor will not run
Blades breaking
Vibration
(there is always some vibration
when the saw is running)
Blade runout (blade not properly
aligned with arm motion)

TROUBLESHOOTING

CAUSE
Problem with ON-OFF switch,
power cord, or outlet.
Motor defective.
Too much tension.
Feeding too quickly.
Wrong blade.
Blade twisting in wood.
Improper mounting of saw.
Mounting surface.
Loose table or table resting
against motor.
Loose motor mounting.
Blade holders out of line.
This product has a Three-year Limited Warranty.
For Warranty details go to www.ryobitools.com
SOLUTION
Have worn parts replaced before using scroll
saw again. Have the proper outlet installed by a
qualified electrician.
Do not attempt any repair. Have repaired by a
qualified service technician.
Adjust tension.
Reduce feed rate.
Narrow blades for cutting thin wood or tight
corners and turns, wide blades for thicker wood
or wide turns.
Reduce side pressure on blade; check blade
tension.
Check mounting.
Check mounting in manual.
Tighten table lock knob.
Tighten mounting screws.
Realign blade.
14