Maintenance - Ryobi P3320 Manual Del Operador

INSTALLING/REMOVING POWER CORD
See Figure 2, page 8.
 Place the power switch in the center, or OFF ( O ) position.
 Route the power cord through the cord retainer.
 Insert the female end of the power cord into the product
as shown.
 Connect the male end of the power cord to the power
source.
 Make sure the power cord is secured before beginning
operation.
STARTING/STOPPING THE PORTABLE FAN
See Figure 3, page 8.
 Connect the portable fan to an AC or DC power supply.
 To start the portable fan, move the power switch to the
left or right.
 To stop the portable fan, place the switch in the center,
or OFF ( O ) position.
WARNING:
Hybrid tools are always in operating condition. Therefore,
switch should always be in the center, or OFF ( O )
position, when not in use.
WARNING:
When servicing, use only identical replacement parts.
Use of any other part could create a hazard or cause
product damage.
NOTE: ILLUSTRATIONS START ON PAGE 8
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
OPERATION
CHANGING PORTABLE FAN SPEED
See Figure 3, page 8.
 For low speed, move the power switch to the LOW
( I ) position.
 For high speed, depress the power switch to the
HIGH ( I I ) position.
TO HANG THE PORTABLE FAN
See Figure 4, page 9.
Using the J Hook to hang the fan:
 Lift the J hook from the slot.
 Use the J hook to hang the portable fan. You may use
a screw to secure the fan in place. Do not overtighten.
NOTE: Be careful not to hang the fan in such a way that
it prevents normal fan operation or damages the cord.
Using the mounting holes to hang the fan:
 Hang portable fan from sturdy location using screws in
mounting holes to secure in place. Do not overtighten.
NOTE: Be careful not to hang the fan in such a way that
it prevents normal fan operation or damages the cord.
ADJUSTABLE HEAD
See Figure 4, page 9.
The portable fan head can be set in a variety of positions.
To switch base positions, adjust base to desired position.

MAINTENANCE

GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and can be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
7 – English