Publicidad
Idiomas disponibles
Idiomas disponibles
3 Set free the two blower springs from the top of the range
hood housing.
4 Flip the blower base to the rear face of the range hood.
5 Insert the two blower springs to the top of the range hood
housing, secure it with the four mounting screws previously
released.
Cabinet Installation
NOTE: Your cabinet must be able to support at least 88 lb (40kg).
1 Drive a mounting screw (from the hardware package)
into each center of the narrow neck of the keyhole slots marked on
the cabinet bottom.
2 Install the 4 - 4 x 8 mm mounting screws. Leave a 1/4" (6.4 mm)
gap between the wall and the back of the screw head to slide
range hood into place 1/4" (6.4 mm).
3 Fix the wiring conduit of the hood.
4 Slide the hood back against the cabinet. Tighten the mounting
screws. Be sure the screw heads are in the narrow neck of the
keyhole slot.
5 Drive 2 pieces of the selected screws in the security holes (See
the image below).
A
A. 4- 4x8 mm mounting screws
B. Security scr
Wall Installation
Install framing for hood support
1 Mark the screw hole locations indicated in the "Outside rear
exhaust" figure.
2 If drywall is present, cut away enough drywall to expose 2 vertical
studs at the indicated holes location. Install two horizontal supports
between two wall studs at the bottom and upper mounting holes
installation location.
3 The horizontal support must be flush with the room side of the
studs. Use cleats behind both sides of the support to secure wall
studs.
4 Reinstall drywall and refinish.
8
partway
B
ews
IMPORTANT: Framing must be capable of
supporting 100 lbs.
Centerline of
Installation
Space
5 Cut holes at marked locations for duct and electrical wiring.
Mounting the hood
1 Drive a mounting screw (from the hardware package)
into each center of the narrow neck of the keyhole slots marked on
the wall's support frame.
2 Install the 2 pieces of the selected screws on the mountings
screws location (see the image). Leave a
between the wall and the back of the screw head to slide range
hood into place.
/
"
1
4
(6.4 mm)
3 Fix the wiring conduit of the hood.
4 Slide the hood back against the wall. Tighten the mounting screws.
Be sure the screw heads are in the narrow neck of the keyhole
slot.
B
C
A. Mounting screws
B. Upper security screws (Wall Installation)
C. Lower security screws (Wall Installation)
5 Drive 2 pieces of the selected screws in the upper security screws
location (see the image above).
6 Drive 2 pieces of the selected screws in the lower security screws
location (see the image above).
7 Connect Ductwork to hood.
View from rear
Cleats
Mounting
Support
partway
/
" (6.4 mm) gap
1
4
A
B
Publicidad
