Ryobi P4360 Manual Del Operador página 12

ADDING BAR AND CHAIN LUBRICANT
See Figure 4.
Use Bar and Chain Lubricant. It is designed for
chains and chain oilers, and is formulated to
perform over a wide temperature range with no
dilution required.
NOTE: Pole saw comes from the factory with no
bar and chain lubricant added. Level should also
be checked after every 20 minutes of use and
refilled as needed.
 Remove oil cap.
 Carefully pour the bar and chain lubricant into
the bar lube reservoir.
 Wipe off excess oil.
 Check and fill the reservoir when quick view oil
indicator is below the second to last indicator
line.
 Repeat as needed.
NOTE: Do not use dirty, used or otherwise
contaminated oils. Damage may occur to the
bar or chain.
NOTE: It is normal for oil to seep from the saw
when not in use. To prevent seepage, empty the
oil tank after each use then run for one minute.
When storing the unit for a long period of time
(three months or longer) be sure the chain is lightly
lubricated; this will prevent rust on the chain and
bar sprocket.
TO INSTALL / REMOVE BATTERY
PACK
See Figure 5.
WARNING:
Always remove battery pack from your tool
when you are assembling parts, making adjust-
ments, cleaning, carrying, transporting or when
not in use. Removing battery pack will prevent
accidental starting that could cause serious
personal injury.
NOTE: To avoid serious personal injury, always
remove the battery pack and keep hands clear of
the lock-out button when carrying or transporting
the tool.
OPERATION
quick view
oil indicator
To install:
 Place the battery pack in the pole saw. Align
raised rib on battery pack with groove in battery
port.
 Make sure the latches on each side of the bat-
tery pack snap in place and battery pack is
secured in pole saw before beginning operation.
To remove:
Locate latches on side of battery pack and de-
press both sides to release the battery pack from
the pole saw.
Page 12 — English
lock-out
button
switch trigger
battery
caP
Fig. 4
Fig. 5