Makita XTU02 Manual De Instrucciones página 9

Installing or removing the shaft
holder
Optional accessory
1.
Insert the hex wrench into the chuck, and then
loosen the chuck with the hex wrench while holding the
spindle with the wrench.
1
2
3
► 1. Hex wrench 2. Chuck 3. Wrench
2. Tighten the shaft holder with a wrench 19 while
holding the spindle with another wrench 19.
1
2
► 1. Shaft holder 2. Wrench
3.
Tighten the shaft into the shaft holder.
1
► 1. Shaft 2. Shaft holder
2
2
9 ENGLISH
4. Tighten the shaft with wrench 19 while holding the
shaft holder with another wrench 19.
2
1
► 1. Shaft 2. Shaft holder
To remove the shaft holder, perform the installation
procedure in reverse.
OPERATION
CAUTION:
Do not mix flammable materials or
operate the tool around flammable materials such
as paint with thinner used as solvent. Failure to do
so may cause an injury.
CAUTION:
Do not mix high viscosity material,
such as mortar or adhesive, in the high speed
mode. You may lose the control of the tool and cause
an injury.
NOTICE:
When you mix the material while the
mixing blade floating out of the material, be care-
ful not to splash the material.
1. Select high speed or low speed according to the
material to be mixed.
2. Hold the rear handle of the tool with one hand
and the grip with the other hand firmly, place the mixing
blade under material fully and turn on the tool after
making sure work site safety.
3. Move the mixing blade up and down during the
mixing operation so that whole part of material can be
mixed.
4. When finishing mixing, turn off the tool, make sure
that the mixing blade has come to a complete stop, and
then pull it out of the mixing container.