Publicidad
Idiomas disponibles
Idiomas disponibles
Removing/Assembling the
Freezer Drawer Handle
Removing the Handle
1
Loosen the set screws
lower side of the handle with a
wrench and remove the handle.
2
Loosen the mounting fasteners
connect to the
freezer drawer
and handle
1
using a
/
in.
4
Allen wrench,
and remove
the mounting
fasteners.
Assembling the Handle
1
Assemble the mounting fasteners
both ends of the handle using a
wrench.
2
Place the handle on the door by fitting
the handle
footprints over
the mounting
fasteners and
tightening the
set screws
1
with a
/
in.
8
Allen wrench.
WARNING
When assembling or disassembling the
handle:
Grasp the handle tightly to avoid dropping it.
Do not swing the handle into nearby people
or animals.
Make sure that the bracket hole of the
handle fits properly into the stopper bolt of
the door. Assemble the set screws to fix
the handle into place.
Make sure that there is not a gap between
the door and handle after assembling the
handle.
Removing/Assembling the
Doors and Drawers
When it is necessary to move the refrigerator
through a narrow opening, removing the doors
is the recommended procedure.
located on the
1
/
in. Allen
8
that
at
1
/
in. Allen
4
INSTALLATION
WARNING
If your entrance door is too narrow for the
refrigerator to pass through, remove the
refrigerator doors and move the refrigerator
sideways through the doorway.
Use two or more people to remove and
install the refrigerator doors. Failure to do
so can result in back or other injury.
Disconnect the electrical supply to the
refrigerator before installing. Failure to do
so could result in serious injury or death.
Do not put hands, feet or other objects into
the air vents or bottom of the refrigerator.
You may be injured or receive an electrical
shock.
Be careful when handling the hinge and
stopper, to avoid injury.
Remove food and bins before detaching the
doors and drawers.
13
Publicidad
