Warnings
GB
WARNING!
Before starting, read carefully the instructions manual and follow these safety instructions.
The plates of danger and of warning on the machine provide important information for safe operation.
Apart from the information in the operating instructions, all the general laws of safety and of the preventions of accidents must be followed.
ELECTRIC CONNECTION.
The voltage indicated on the rating plate must correspond to the voltage of the electric
source.
Safety class 1 - The units may only be connected to properly earthed electric sources. Only use or replace electric supply cables for this unit
which correspond to the types indicated by the manufacturer. See the operating instructions for the order no. and types.
Switching-on procedures produce brief voltage drops. In the case of unfavourable power source conditions, interference of other devices may
arise. No interruptions are to be expected in the case of power supply resistance of <0.15 Ohm.
Never touch the mains plug with wet hands.
Do not run over, crush or pull the power supply cable or extension lead, otherwise it may be damaged. Protect the cable from heat, oil and sharp
edges.
Regularly examine the power supply line for damage such as cracking or ageing. If damage is discovered, the cable must be replaced before
further use of the unit.
APPLICATION.
Before use, check that the unit and operating equipment, in particular, the power supply cable and the extension lead,
are in perfect condition and are safe to operate. Do not use the units if it's not in perfect condition.
Never suck up explosive or combustible gases, liquids or dusts, or undiluted acids and solvents! Substances to avoid also include petrol, paint
thinner and fuel oil which could form explosive fumes or mixtures by being in turbolence with the air under suction. In addition, the list includes
acetone, undiluted acids and solvents, as well as aluminum and magnesium dusts. These substances can also attack the materials used in the
unit.
Do not draw in burning or glowing objects.
Do not direct the unit at people or animals.
In case of low temperatures, the unit may not be used.
The appropriate safety regulations must be observed when using the unit in dangerous areas (e.g. petrol stations). It is forbidden to operate the
unit in potentially explosive locations.
This machine is suitable collective use, such as hotels, schools, hospitals, industries, shops, offices and residences.
OPERATION.
The operator must use the unit in accordance with the regulations. He/she must take local conditions into consideration
and be aware of other people, especially children, when operating the unit.
The unit may only be used by persons who have been instructed in how to use it or who have proved their ability to operate it and who have
been expressly commissioned to use it.
The unit may not be operated by children or by the frail and infirm without supervision.
Never leave the unit unattended unless you have switched it off and pulled out the mains power plug..
TRANSPORT.
Switch off the motor and secure the unit before transporting.
MAINTENANCE.
Switch off the unit prior to cleaning and maintenance and before replacing components. Pull out the mains plug if the
unit is mains operated. Switch off the unit when changing over to another function.
Repairs may only be carried out by authorized customer service centers or by specialists in this field who are familiar with all relevant safety
regulations.
Commercial units which may be used in different locations are subject to a safety check according to VDE 0701.
ACCESSORIES AND SPARE PARTS.
Only use accessories and spare parts which have been approved by the
manufacturer.
Original accessories and spare parts guarantee that the unit can be operated safely and without any breakdowns.
VACUUM CLEANER.
This unit must not be used for removing dust or liquids which iare hazardous to your health unless
specifically indicated on the unit.
Comply with the safety information in the operating instructions!
Do not keep the unit in sub-zero temperatures.
ATTENTION!
If the feeding cable is damaged, it must be replaced near an authorized center technical
attendance from the constructor or in any case by a professional qualified figure, to preview any risk.
pag. 7