Publicidad
Idiomas disponibles
Idiomas disponibles
BM 2609932751 09-09:BM 2609932751 09-09 9/3/09 7:20 AM Page 8
"TRI-CONTROL" PADDLE SWITCH
(Model 1209 only)
The "Tri-Control" Paddle Switch enables the
operator to control the switch functions of
"Lock-OFF", "ON/OFF" and "Lock-ON".
TO UNLOCK SWITCH
AND
TURN
TOOL
"ON": Push paddle lever
FORWARD (toward the
spindle) then squeeze
the paddle lever.
TO SWITCH TOOL "OFF": Release pressure
on paddle lever. The switch is spring loaded
and will return to "OFF" position automatically.
The "Lock-ON" feature, incorporated into the
paddle switch, is a convenience for long
operations.
TO LOCK SWITCH "ON": After paddle switch
has been activated push paddle lever
completely FORWARD and release paddle
lever.
TO SWITCH TOOL "OFF": Squeeze and then
release paddle lever. The switch is spring
loaded and will return to "OFF" position
automatically.
SELECTING GRINDING WHEELS
Before using a grinding wheel,
W RNING
be certain that its maximum
safe operating speed is not exceeded by the
nameplate speed of the grinder. Do not
exceed the recommended wheel diameter.
Grinding wheels should be carefully selected
in order to use the grinder most efficiently.
Wheels vary in type of abrasive, bond,
hardness, grit size and structure. The correct
type of wheel to use is determined by the job.
INSTALLING ACCESSORIES
Be sure that the diameter of
C UTION
the shank is the same size as
the inside diameter of the collet.
Models 1209, 1210 & 1215 are equipped with
a 1/4" collet.
Operating Instructions
The tool is switched "ON" by the switch button
located at the side of the motor housing. The
switch can be locked in the "ON" position, a
convenience for long grinding operations.
TO TURN THE TOOL "ON" without locking it,
slide the switch button forward by applying
1 1
0 0
pressure ONLY at the REAR portion of the
button. When pressure is released the switch
button will snap to "OFF" position.
TO LOCK THE SWITCH "ON", slide the switch
button forward and press "IN" the FRONT
portion.
TO UNLOCK THE SWITCH, simply press and
release the REAR portion of the button. Switch
is spring loaded and will snap back
automatically.
torque from the motor can cause the tool to
twist.
Start the tool before applying to work and let
the tool come to full speed before contacting
the workpiece. Lift the tool from the work
before releasing the switch. DO NOT turn the
switch "ON" and "OFF" while the tool is under
load; this will greatly decrease the switch life.
1. Place the (22mm) spindle lock wrench that
is provided onto the spindle to prevent the
spindle from rotating.
2. Hold wrench in place and rotate collet nut
counter-clockwise with the (14mm) wrench that
is provided.
3. Insert three fourths of shank of accessory
into the collet, and securely tighten with the
wrench provided.
NOTE: When replacing collets on the model
1215, loosen the collet nut and remove
together with collet 6, then screw in new collet.
Repeat steps 1 and 2 of above and remove
accessory.
-8-
SLIDE ON-OFF SWITCH WITH LOCK
(Models 1210 & 1215 only)
Hold the tool with both hands
W RNING
while starting the tool, since
(Models 1209 & 1215 only)
REMOVING ACCESSORIES
Publicidad
