Publicidad
Table of Contents
Part/Hardware Identifi cation
Assembly Steps
Français
Español
Safety
Warranty
Hardware Identifi cation
1
FASTENER - 12
!
WARNING
Use of a TV that is too heavy or large is hazardous. A
TV that is too heavy will create a risk of a tip-over that
can cause severe injury or death. A TV that is too large
for the available space might be accidentally pushed
or bumped off the furniture, or subject to tip-over.
• Check the size and weight of your TV. Compare it to
the diagram below – before you begin assembly!
• This Sauder unit is designed for use with televisions
weighing less than 50 pounds. Never use with a TV
that weighs more.
• The size of the television, front-to-back and side-to-
side, must fi t within the space defi ned in the diagram.
• Never place the front edge of the TV past the
front edge of the TV support shelf (or stop molding –
if equipped)
• Never allow the sides of the TV to extend past
the side edges of the TV support surface.
• If the TV has a CRT picture tube, the picture tube
cone may extend past the rear of the support shelf.
• Be sure to apply the warning label as instructed in
the last assembly step. The label provides important
safety related information.
Page 2
Part Identifi cation
2
3-6
7
8
9-10
B
11
2
WARNING LABEL - 1
50 lbs.
5
22 kg
22,68
(Refer to the last step for proper location and application)
www.sauder.com
å
Use this part identifi cation to help identify the parts.
A
SHELF (3)
B
METAL FRAME (2)
22,68
22 kg
15-1/2"
15-1/2"
A
A
A
41-1/2"
41-1/2"
50 lbs.
50 lbs.
B
422313
Publicidad
