Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY STEp 1
FRONT STABILIZER TUBE
10
ce11-OM-rev2_4.indd 10-11
HARdWARE fOR STEp 1 :
BOLT (A)
40 mm
Qty: 4
FLAT WASHER (B)
MAIN FRAME
20 mm
Qty: 4
A
Open hardware for step 1.
BOLTS (A)
B
Attach the front stabilizer
FLAT
WASHERS (B)
tube to the main frame
using 2 bolts (a) and 2 flat
REAR
STABILIZER
washers (b).
TUBE
C
Attach the rear stabilizer
tube to the main frame
using 2 bolts (a) and 2 flat
washers (b).
ASSEMBLY STEp 2
HARdWARE fOR STEp 2 :
BOLT (D)
65 mm
Qty: 1
RUBBER LANDING PAD
FOLDING
HANDLE
CONSOLE MAST
LEAD WIRE
CONSOLE CABLE
BOLT (D)
MAIN FRAME
A
Open hardware for step 2.
B
gently rest the console mast on the rubber
landing pad as shown.
C
Attach lead wire to console cable. Pull
lead wire through the console mast. After
pulling the lead wire through the mast, the top of
the console cable should be located at the
top of the mast.
NOTE: Feed the console cable into the
bottom of the console mast by hand before
pulling it through using the lead wire. Make
sure the console cable is pulled all the way
through so it will not get pinched when the
console mast is folded.
Rotate folding handle counterclockwise until
D
loose. Place the console mast into the main
frame as shown. Attach the console mast to
the main frame using 1 bolt (d).
E
Lift console mast upwards until folding
handle clicks into place and the console
mast is secured in the upright position.
F
Rotate folding handle clockwise until tight.
The folding handle may need to be loosened to
engage locking mechanism before tightening.
11
8/15/11 2:13 PM
Publicidad
Tabla de contenido
