Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY STEp 5
TEFLON WASHERS (J)
HANDLEBAR
SPRING WASHER (L)
NUT (N)
FLAT WASHER (M)
PEDAL ARM
BOLT (K)
BRACKET
14
ce11-OM-rev2_4.indd 14-15
HARdWARE fOR STEp 5 :
TEFLON
BOLT (K)
WASHER (J)
82 mm
28.4 mm
Qty: 2
Qty: 4
SPRING WASHER (L)
FLAT WASHER (M)
NUT (N)
13.5 mm
16 mm
Qty: 2
Qty: 2
Qty: 2
A
Open hardware for step 5.
B
Place teflon washers (J) on both sides of the
handlebar. While holding teflon washers
(J), slide handlebar into the pedal arm
bracket.
C
Align bottom of handlebar with the bracket
on pedal arm.
D
Secure the joint with 1 bolt (k), 1 flat washer
(m), 1 spring washer (l) and 1 nut (n).
E
Repeat on other side.
ASSEMBLY STEp 6
CONSOLE
CONSOLE CABLE
PRE-ATTACHED
SCREWS
CONSOLE MAST
NOTE: there is no hardware bag for this step. All
hardware is pre-attached.
Attach the console cable to the open port
A
in the back of the console.
Carefully tuck the console cable into
B
the console mast before attaching
the console. Attach the console to
the console mast using the 4 pre-
attached screws (the screws will have to
be removed from the console first).
NOTE: Be careful not to pinch any
wires while attaching the console.
YOU ARE FINISHED!
8/15/11 2:13 PM
15
Publicidad
Tabla de contenido
