Publicidad
Idiomas disponibles
Idiomas disponibles
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
SUPPLIER'S DECLARATION OF CONFORMITY
Brand: BaBylissPRO
®
Model No.: FX890
Description: Clipper
Responsible Party: Conair LLC
1 Cummings Point Road
Stamford, CT 06902
(203) 351-9000
Standards: FCC Part 15 Subpart B, ANSI C63.4-2014
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesirable operation.
DATE OF ISSUE: 01/06/2022
FX890 IB-17257C.indd 7-8
FX890 IB-17257C.indd 7-8
CLIPPER MAINTENANCE
INSTRUCTIONS
MAINTENANCE OF THE BLADES
Always apply oil to the blades before and after use. This will ensure maximum cutting
performance and proper maintenance. Hold the clipper away from your body in a
downward position, and apply a drop of BaBylissPRO lubricating oil on the front and
sides of the cutter blade. Wipe off excess oil with a soft, dry cloth.
HOW TO USE COMB ATTACHMENTS
To use the comb attachments, turn the clipper to " " position. Slide the
comb attachment onto the top of the clipper blades and then pull down
and over the back of the blade. To remove, pull up on the back of the
comb attachment and then pull away from the blade.
REPLACING (REMOVING) BLADE SET
Step 1. Unplug the unit and adjust the taper as
shown on illustration A.
Step 2. Remove the screws and fixed blade.
Save the screws.
Step 3. Lift off the small moving blade and place
new blade on the plastic oscillator
(see illustration B).
Step 4. Replace the fixed blade using the screws and lightly tighten them. Adjust the
teeth to a gap of 1/32" (1 mm) to 1/16" (1.5 mm) with the small moving blade as
centered and as parallel as possible to the fixed blade's teeth (see illustration C).
C.
Fixed Blade
Small Moving Blade
A.
B.
Plastic Oscillator
Taper
Small Moving Blade
1/32" to 1/16"
2023/1/17 11:56 AM
2023/1/17 11:56 AM
Publicidad
