Special Safety Instructions For This Machine; Designated Use; Supplied Parts; Unpacking The Appliance - Proficook PC-UM 1006 Instrucciones De Servicio

• Children should be supervised at all times in
order to ensure that they do not play with the
device.
Special Safety Instructions for
this Machine
WARNING:
• Risk of cuts! The mixer blades are sharp!
• Before replacement of accessories or ad-
ditional parts which move during operation, the
device must be switched off and cut off from
the mains.
• Do not touch moving parts.
• Before replacing accessory parts, wait until the
knife has stopped.
• Always check that the accessories are seated
solidly and securely before switching the
device on.
• Do not operate the appliance for more than
2 minutes. Allow it to cool for around 1 minute
before using it again.
• The machine should only be used under super-
vision!
• Do not manipulate any of the safety switches!
• Do not remove the lid during operation.
• Do not put your fingers into the filler opening.

Designated use

This device is used for
• Mixing of liquids
• For chopping firm foodstuffs
• For crushing ice.
Do not use for too hard foodstuffs such as nuts or
chocolate.
It is intended for the use in private households and
similar applications.
It is only to be used as instructed in this user
manual. The appliance is not intended for com-
mercial use.
Any other use shall be considered as not intended
use and can lead to material damage or even
personal injury.
The manufacturer shall not be liable for damages
caused by not intended use.

Supplied parts

1 base device with motor
1 cap for the filler open-
ing
1 lid with filler opening
for mixing vessel
1 mixing vessel

Unpacking the appliance

1. Remove the device from its packaging.
2. Remove all packaging materials like foils, filling
materials, cable holders, and carton packaging.
3. Check the scope of deliveries for completeness.

NOTE:
There may still be dust or production remains on
the device. We recommend that you clean the
device as described under "Cleaning".

Description of the Parts

1 Fill opening cap
2 Mixing jug lid with fill opening
3 Mixing jug
4 Blade block
5 Screw mount for the blade block
6 Drive wheel
7 Base unit with motor
8 Control panel
9 Function indicator lights

Assembly

Assemble the blade block (see Fig A und B)
1. Turn the mixing jug on its head.
2. Place the blade block onto the seal on the base
of the jug. The drive wheel points outwards.
3. Put the screw mount onto the thread on the
base of the mixing jug.
4. Left-handed thread! Turn the screw mount
anti-clockwise.
1 blade block
1 screw mount for
the blade block
39