Recipe Suggestion - Proficook PC-UM 1006 Instrucciones De Servicio

Ocultar thumbs Ver también para PC-UM 1006:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 25
CAUTION:
• Always wait until the mixing knife has stopped
turning.
• The glass can crack in case of high tempera-
tures! Do not fill in liquids with a temperature
over 60°C.
• Do not overfill the mixing vessel! You can fill in
a maximum of 1.8 litres. Observe the grada-
tion on the vessel.
• Do not fall short of the quantity of 0.25 litres!
The mixing knifes could run dry and damage
the seal.
• Never put hard ingredients into the mixing jug!
Ingredients such as nuts or blocks of choco-
late damage the appliance.
NOTE:
• The mixer functions only when the symbols
▼ and ▲ are exactly one above the other.
• The device is intended for short-time opera-
tion. Wait for 1 minutes after operation for
2 minute.
• Froth requires a large capacity. Reduce quanti-
ties of liquids which produce a lot of froth.
• Keep one hand on the lid if you are crushing
ice or if there is a large quantity of ingredients.
1. Prepare the ingredients. Refer to the table on
page 40.
2. Set the mixing vessel onto the base device, if
that has not yet been done.
3. Fill the jug with the ingredients you want to mix.
4. Set the lid with the cap onto the vessel.
NOTE:
Do you want to add sugar or spices to your mixed
drink?
• First switch off the device.
• Remove the cap and fill in through the
opening.
• Reinsert the cap into the lid.
WARNING:
• Do not operate the mixing vessel empty or
without the lid.
WARNING:
• Do not reach into the mixing vessel! The
blades are sharp and rotate at high speed.
Serious injuries could result.
5. Plug the mains plug into a properly installed
220 - 240 V, 50 Hz earthed socket.
6. Use the "POWER" button to switch on the appli-
ance.
7. Press the "CONTINUE" button or select a func-
tion using the "SELECT" button.
8. Press the "START/STOP" button after select-
ing a function. The motor starts. The remaining
operating time is shown on the display.
End operation
1. First press the "START/STOP" button and then
the "POWER" button.
2. Wait until the mixer blade has come to a com-
plete stop.
3. Lift the mixing jug off the base of the appliance
to pour out your drink.
4. Disconect the mains plug from the outlet.

Recipe Suggestion

Ingredients
500 ml cold milk, Fat content: 1.5%
2 Bananas
1 Apple, peeled and cored
4 Tablespoons frozen berries
Juice of one lemon
Preparation 1. Peel the bananas, cut into
pieces and add to the mixing
jug.
2. Peel and core the apple, cut
into quarters and add to the
jug.
3. Add the berries and pour in the
juice of one lemon.
4. Start the mixer at function
"1" and pour the milk slowly
through the fill opening.
5. The process ends automati-
cally after 120 seconds.
41

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido