Dongcheng DSP05-180 Manual Del Usuario página 6

Safety warnings common for
polishing operations:
a)This power tool is intended
to function as a polisher.
Read all safety warnings,
instructions, illustrations
and specifications provided
with this power tool. Failure
to follow all instructions listed
below may result in electric
shock, fire and/or serious injury.
b) Operations such as grinding,
sanding, wire brushing, hole
cutting or cutting-off are not
to be performed with this
power tool. Operations for
which the power tool was not
designed may create a hazard
and cause personal injury.
c) Do not convert this power
tool to operate in a way
which is not specifically
designed and specified by
the tool manufacturer. Such a
conversion may result in a loss
of control and cause serious
personal injury.
d) Do not use accessories
which are not specifically
designed and specified by
the tool manufacturer. Just
because the accessory can be
attached to your power tool, it
does not assure safe operation.
e) The rated speed of the
accessory must be at least
EN
6
equal to the maximum speed
marked on the power tool.
Accessories running faster than
their rated speed can break
and fly apart.
f) The outside diameter and the
thickness of your accessory
must be within the capacity
rating of your power tool.
Incorrectly sized accessories
cannot be adequately guarded
or controlled.
g) The dimensions of the
accessory mounting must
fit the dimensions of the
mounting hardware of the
power tool. Accessories that
do not match the mounting
hardware of the power tool
will run out of balance, vibrate
excessively and may cause loss
of control.
h) Do not use a damaged
accessory. Before each use
inspect the accessory such
as abrasive wheels for chips
and cracks, backing pad for
cracks, tear or excess wear,
wire brush for loose or
cracked wires. If power tool or
accessory is dropped, inspect
for damage or install an
undamaged accessory. After
inspecting and installing an
accessory, position yourself
and bystanders away from