stayer HDBL1820K Manual De Instrucciones página 16

gb
INSERTING THE BATTERY
Set the rotational direction switch 7 to the centre
position (lock-off). Insert the charged battery 8 into the
handle until it can be felt to engage and is seated flush
on the machine.
SWITCHING ON AND OFF
To start the machine, press the On/Off switch 6 and
keep it depressed.
The machine runs with variable speed
between 0 and maximum, depending on the
pressure applied to the On/Off switch 6. Light
pressure on the On/Off switch 6 results in low
rotational speed, thus allowing drilling to begin in a
smooth, controlled manner. Further pressure on the
switch results in an increase in speed.
To switch off the machine, release the On/Off switch
6.
Do not strain the machine so heavily that it comes to
a standstill.
The machine is not suitable for stationary operation,
e.g., in a drill stand.
OVERLOAD CLUTCH
If the drill bit jams or edges, the drive to the
drill spindle is interrupted.
Due to the arising forces always hold the
machine firmly with both hands and provide for a
secure stance.
Before pulling out a stuck tool insert, first remove the
machine from it.
REVERSING THE ROTATIONAL DIRECTION
Operate the rotational direction switch 7
only at a standstill.
The rotational direction switch 7 is used to reverse the
rotational direction of the machine. However, this is not
possible with the On/Off switch 6 actuated.
Right Rotation
Turn the rotational direction
switch through to the left
stop (normal operation:
drilling, screwdriving, etc.).
Left Rotation
Press the rotational
direction switch through
to the right stop (for
loosening and unscrewing
screws and nuts).
-
IMPACT STOP SWITCH
Operate the impact stop switch 5 only when at a
standstill.
Set the impact stop switch 5 to the desired position:
BATTERY CHARGING
A battery that is new or has not been used for a longer
period does not develop its full capacity until after
approximately 5 charging/discharging cycles.
To remove the battery 8, press the unlocking buttons
9 and pull out the battery downwards. Do not exert
any force.
The battery is equipped with an temperature control
which allows charging only within a temperature range
of between 0 °C and 45 °C.
A long battery service life is achieved in this manner.
A significantly reduced working period after charging
indicates that the batteries are used and must be
replaced.
Observe the notes on environmental protection.
3_ASSEMBLY
INTENDED USE
The machine is intended for hammer drilling in
concrete, brick and stone. It is also suitable for drilling
without impact in wood, metal, ceramic and plastic.
Machines with electronic control and right/left rotation
are also suitable for screwdriving and thread cutting.
16 -
Drilling
Hammer drilling
Hammer