Publicidad
Idiomas disponibles
Idiomas disponibles
BM 1609929B61 3/03
3/12/03
the tool come to full speed before contacting
the workpiece. Lift the tool from the work
before releasing the switch. DO NOT turn the
MOTOR HOUSING RELEASE LEVER
(1754G ONLY)
Your tool is equipped with a motor housing
release lever that will allow you to rotate the
spindle in either direction 90˚. To use this
feature, pull release lever in direction of
arrow to release housing, and rotate housing
until it clicks into place.
SELECTING GRINDING WHEELS
Before using a grinding
WARNING
!
wheel, be certain that its
maximum safe operating speed is not
exceeded by the nameplate speed of the
grinder. Do not exceed the recommended
wheel diameter.
DISC GRINDING WHEELS
Grinding wheels should be carefully selected
in order to use the grinder most efficiently.
Wheels vary in type of abrasive, bond,
hardness, grit size and structure. The correct
type of wheel to use is determined by the
job. Use disc grinding wheels for fast
grinding of structural steel, heavy weld
beads, steel casting, stainless steel and
other ferrous metals.
SELECTING SANDING DISC
Sanding discs are made of extremely hard
and sharp aluminum oxide grits, phenol-
resin bonded to a sturdy fiber backing for
fast heavy-duty service and long life. The
discs vary as to size and spacing of the
abrasive grits. OPEN COAT (type H) — used
for soft materials and on paint or varnish.
CLOSED COAT (type K) —used for metal,
10:48 AM
Page 9
switch "ON" and "OFF" while the tool is
under load; this will greatly decrease the
switch life.
Grinding Operations
GRINDING TIPS
Efficient grinding is achieved by controlling
the pressure and keeping the angle between
wheel and workpiece at 10° to 15°. If the
wheel is flat, the tool is difficult to control. If
the angle is too steep, the pressure is
concentrated on a small area causing
burning to the work surface.
WARNING
!
grinding action and put dangerous stresses
on the wheel.
When grinding with a new wheel be certain
to grind while pulling tool backwards until
wheel becomes rounded on its edge. New
wheels have sharp corners which tend to
"bite" or cut into workpiece when pushing
forward.
Sanding Operations
hardwood, stone, marble and other
materials.
Sanding discs range in grit from 16 (very
coarse) to 180 (very fine). To obtain best
results, select sanding discs carefully. Many
jobs require the use of several grit sizes and
at times both "open coat and closed coat"
discs are required to get the job done faster.
See chart for application examples.
-9-
Excessive or sudden pres-
sure on the wheel will slow
Publicidad
