Vonyx 178.610 Manual De Instrucciones página 3

UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the product can be irreparably damaged. The product must also be
directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
OVERVIEW
1. Mode
Turn this knob to select the mode for the LED's on the front
2. Colour
See table below
3. Sensitivity / Speed
See table below
Function LED output
selector description
Mood Auto change
"VU meter"
Meter
single colour
"VU meter"
Mix
multi colour
Pulse Strobe
Party Change
4. Mediaplayer
Mediaplayer for playing MP3 songs via USB, SD or BT
technology.
5. Level Mic / Line1
Volume control for the microphone or line 1 input.
6. Level Player / Line 2
Volume control for the player and line 2 input.
7. Treble
Adjust high tone control.
8. Bass
Adjust low tone control.
9. MIC / Line 1 Input
XLR jack input for connecting microphone or audio source with
line level output (e.g. mixer, CD player)
10. RCA Line 2 Input
RCA jack input for connecting audio source with line level
output (e.g. mixer, CD player)
11. Jack 3.5 Line 2 Input
3.5mm (1/8") jack to connect an audio source to line 2.
12. Link output
XLR jack output for connecting another active loudspeaker.
13. Player / Line 2 Switch
Press this button to select between Player or Line 2 input.
14. LED Power
Indicator lights up when power turned on.
15. Power On/Off
Turns the loudspeaker on/off. Make sure the volume knob is set to minimum before turning it on.
16. Power Input
Connect the included power cable to this input and connect the other end of the cable to a power source.
Sound Colour Sensitivity
controlled potentiometer potentiometer
No -
Yes Colour select
Yes -
Yes Colour select Sound sensitivity
No -
-
-
-
Speed
3