Descargar Imprimir esta página

Stanley SG 3200 Traducción Del Manual Original página 11

Ocultar thumbs Ver también para SG 3200:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 95
wire brush. Thereafter service the spark plug after every
50 hours of operation.
- Pull off the spark plug boot with a twist.
- Remove the spark plug with the supplied spark plug
wrench.
- Assemble in reverse order.
8.4 Changing the oil and checking the oil level
(before using the machine) (Fig. 9)
The motor oil is best changed when the motor is at
working temperature.
- Only use motor oil (15W40/<0
- Place the generator on a slightly inclined surface so
that the oil drain plug is at the lower end.
- Open the oil filler plug (8).
- Open the oil drain plug (9) and let the hot engine oil
drain out into a drip tray.
- After the old oil has drained out, close the oil drain plug
and place the generator on a level surface again.
- Fill in engine oil up to the top mark on the oil dip stick.
- Important: Do not screw the dipstick in to check the oil
level, simply insert it up to the thread.
- Dispose of the waste oil properly.
8.5 Oil shortage cut-out
The oil shortage cut-out (10)
oil in the engine. In this case it will not be possible to
start the engine or it will cut out automatically after a
short period of time. It cannot be started again until the
engine oil has been topped up (see point 8.4).
9. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material and
can therefore be reused or can be returned to the raw
material system.
The unit and its accessories are made of various types
of material, such as metal and plastic. Defective
components must be disposed of as special waste. Ask
your dealer or your local council.
o
C: 5W30).
responds if there is too little
10. Transport
These requirements must be met:
• Generator is turned off
• Generator is cooled down
• Petrol cock (14) is at "OFF" position
• At least one person per transportation handle (18)
ATTENTION! Slipping or falling unit can
crush hands and feet.
Carry the generator on transportation handles:
• Lift the generator evenly
• Carry the generator to the operating place
• Drop the generator evenly
Carry the generator with wheel (15) and carry
handle (16):
• Assemble wheels and carry handle (see chapter 6.1
and 6.3)
• The generator can be carried by lifting the carry
handle (16)
11
G
B

Publicidad

loading