Publicidad
Idiomas disponibles
Idiomas disponibles
Important !
If the cabinet has been horizontally placed during transport, please wait 2 hours before starting
up the cabinet. Remember to remove the transport safety device on the compressor. Remove
the whole bar as shown in fig. 1.8.
Connect the cabinet to a socket and turn on the switch on the
control panel, see fig. 1.9.
Thermostat
The thermostat is placed in the control panel, see fig. 2.0.
The thermostat has been pre-set and in most cases it is not
necessary to adjust the settings.
When turning on the cabinet the display will show the current temperature in the cabinet.
Display set temperature:
Press this key and the display will show the set temperature. Press the key again to
return to normal reading
Set new temperature:
Press this key continuously for more than 3 seconds and the display shows the set
temperature.
Press this key to increase the set temperature.
Press this key to lower the set temperature.
Press this key to save the new settings. The display will flash with the new value and will
then return to normal reading.
Alarm codes:
'P1' Flashing in the display: indicates that the cabinet sensor is defective. The cabinet will strive
to keep the set temperature until it has been repaired.
'P2' Flashing in the display: indicates that the evaporator sensor is defective. This does not
influence the operation of the cabinet, but should be repaired as soon as possible.
Defrosting
The cabinet defrosts automatically with pre-set intervals. If the door to the cabinet is opened or
the contents of the cabinet is changed frequently it may become necessary to defrost the cabinet
manually.
Pressing this key continuously for more than 3 seconds will start a manual defrosting and
then return to normal operation.
Defrosted water runs to a container placed in the compressor compartment and evaporates.
Maintenance and cleaning
Switch the cooler off at the socket.
The cabinet must be periodically cleaned. Clean the external and internal surfaces of the cabinet
with a light soap solution and subsequently wipe dry.
External surfaces can be maintained using steel oil.
English
6
Publicidad
