Sharp EM-KS3CEU Manual Del Usuario página 7

Removal of Battery
EM-KS3
• To remove the battery, peel up the rubber foot mat and remove the
6 screws on the wooden deck, then the 10 screws securing the metal
plate. Now unplug the battery connector and remove. Ensure that the
battery terminals are not shorted out. Dispose of the battery as required
by your local regulations.
EM-KS4
• To remove the battery, peel up the rubber foot mat and remove the 11
retaining screws from the metal plate, the plate can now be taken o
to reveal the battery. Now unplug the battery connector and remove.
Ensure that the battery terminals are not shorted out. Dispose of the
battery as required by your local regulations.
Disposal of this equipment and batteries
• Do not dispose of this product or its batteries as unsorted
municipal waste. Return it to a designated collection point
for the recycling of WEEE in accordance with local law. By
doing so, you will help to conserve resources and protect
the environment.
• Most of the EU countries regulate the disposal of batteries
by law. Recycling symbol appears on electrical equipment,
packaging and batteries to remind users to dispose these
items correctly. Users are requested to use existing return
facilities for used equipment and batteries. Contact your
retailer or local authorities for more information.
CE and UKCA statement:
• Hereby, Sharp Consumer Electronics Poland sp. z o.o. declares that this
equipment is in compliance with the essential requirements and other
relevant provisions of RED Directive 2014/53/EU and PN-EN 17128:
2021-03.
• The full text of the EU and UKCA declaration of conformity is available by
following the link www.sharpconsumer.com/documents-of-conformity/
Cleaning
• When cleaning your e-scooter, please make sure that it is turned o , the
battery charger has been unplugged, and the charging port cap on the
device is covered.
• It is recommended to use a soft and slightly damp cloth. If there are
stubborn dirt residues that are di cult to clean, use a toothbrush and
repeatedly brush to remove it. After removing the stain, use a soft and
slightly damp cloth with an appropriate amount of detergent to remove
any residue.
NOTES:
• Do not use alcohol or other solvents to avoid corrosive chemical products
from damaging the paint on the surface of the body and its internal
structural parts.
• Do not use high-pressure water jets to clean the scooter.
• Clean the e-scooter regularly.
Care and Maintenance
• When not using the e-scooter, please store it in a dry environment to
avoid damage to electronic components due to moisture.
• Do not store the e-scooter outside for an extended period of time. This
will provide excessive exposure to sunlight, high temperature or low
temperature may damage the e-scooter and accelerate the wear of tires
and batteries.
• Do not touch the disc brake disc immediately after using the disc brake
of the electric scooter, as there is a danger of high temperature burns!
• Disc brake adjustment: If the brake is too tight, use the provided hex
wrench to slightly loosen the screw holding the brake cable on the disc
brake to release the brake tension. Then slightly extend the position of
the brake cable bolt compared to the last time. If the brake is too loose,
perform the opposite operation and adjust the brake cable.
• If any damage is found on your e-scooter, do not store indoors due to
potential re risk.
• Should you experience any issues with the care and maintenance of your
e-scooter, contact your dealer or SHARP Support or advice.
EN