Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING AND CARE
This product contains no user serviceable parts. Refer to qualified service
personnel.
CLEANING OUTSIDE SURFACES
1.
Make sure the iron is unplugged and has completely cooled.
2.
Wipe the soleplate and outer surface with a soft, damp cloth. Water
and small amounts of gentle household soaps, such as dishwashing
liquid, can be used. Never use heavy-duty cleaners, vinegar or
abrasive scouring pads that may scratch or discolor the iron.
3.
After the iron has been thoroughly dried, turn the iron back on and
lightly steam over an old cloth. This will help remove any reside left
in the steam holes.
4.
When finished cleaning, turn iron off and allow time to cool
before storing.
AUTO-CLEAN™ SYSTEM
Use this feature to keep the iron free of build-up. For optimal results over
time, it is recommended that you clean your iron every 2-4 weeks. Homes
with harder water should clean their iron more often, every 1-2 weeks.
1.
Fill the water tank well below the MAX fill line. Plug in the iron.
Tip: When pulling the cord out of the housing, be sure not to go past
the warning tape. Pulling the cord too far can result in damage.
2.
Select the Wool Fabric setting (Number 5) on the SmartSteam™ dial
and stand the iron on its heel while it preheats.
3.
Allow the iron to heat to desired temperature for about 2 minutes,
then turn the dial to the MIN setting and unplug from the outlet.
4.
Hold iron over a sink with the soleplate facing down. Press the
AutoClean™ button. Be careful, as hot water and steam will come
out of the vents.
5.
Continue to hold the button down until all of the water has emptied.
If necessary, slightly tilt the iron from side-to-side and front-to-back
to aid the process.
6.
When finished, release the AutoClean™ button and place the iron on
its heel rest. Allow the iron to completely cool before storing.
All manuals and user guides at all-guides.com
8
Publicidad
