Publicidad
Step 11
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the lower
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten a DOOR (G2) to the LEFT END (B). Use the
å
SCREWS in the HINGES. See the next step for adjustments.
Peel a BUMPER from the BUMPER CARD (29M). Stick a
å
BUMPER on the DOOR where it comes in contact with
the BOTTOM (D).
Fasten two PULLS (7K) to the DOOR (G2). Use four
å
SILVER 3/4" MACHINE SCREWS (20S).
Repeat this step for the other DOOR (G2).
å
Hinge
www.sauder.com/services
Stop
Mounting
screw
7K
20S
SILVER 3/4" MACHINE SCREW
(8 used in this step)
B
G2
29M
408739
Want options? Customize
your item with add-on
hardware kits available
on sauder.com.
D
Page 15
Publicidad
