Step 3
Carefully turn the ENDS (A and B) over.
å
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into
å
the ENDS (A and B) until the shoulders of the SCREWS
rest on the surfaces of the ENDS.
NOTE: Do not overtighten the SCREWS.
å
Now, slide the END MOLDINGS (N) onto the ENDS (A
å
and B). To do this, line up the groove in the MOLDINGS
over the head of the SCREWS in the ENDS. Using your
hands, apply pressure on the MOLDING as you guide the
MOLDING onto the END.
NOTE: If the MOLDING comes up off of the SCREWS,
å
remove it and slide it on again.
www.sauder.com/services
B
These edges
should be even.
BLACK 9/16" FLAT HEAD SCREW
A
N
32S
(4 used in this step)
408739
Some assembly
(and snacks) required.
These edges
should be even.
N
Shoulder
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
Page 7