Makita BO4555 Manual De Instrucciones página 4

FUNCTIONAL DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Switch action
1
► 1. Switch
CAUTION:
• Before plugging in the tool, always check to see
that the tool is switched off.
To start the tool, press the " I " side of the switch. To
stop the tool, press the " O " side of the switch.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing abrasive paper
Open the paper clamp by raising on the lever to release from the
locking port and then Insert the paper end into the clamping part,
aligning the paper edges even and parallel with the sides of the
base. (Bending the paper beforehand makes attachment easier).
Once the paper is in place, return the lever to its original position.
Repeat the same process for the other end of the base,
maintaining the proper paper tension.
After inserting the paper, make sure the clamping part
hold it securely. Otherwise the paper will be loose
and subject to slippage, resulting in uneven sanding
operation.
3
► 1. Punch plate 2. Sandpaper 3. Guide
When using the dust bag, make holes in the abrasive
paper using the punch plate as follows:
1. Set the tool upside down.
2. Place the punch plate over the abrasive paper so
that the bent sides of the punch plate are flush
with the paper edges.
3. Press the punch plate to make holes in the abra-
sive paper.
CAUTION:
• Be sure to remove the punch plate before oper-
ating the tool.
4 ENGLISH
1
2