Descargar Imprimir esta página

Ryobi RY40306 Manual Del Operador página 14

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE: For the first use or if the unit has been stored for a
long period of time, it is recommended to use a pressurized
connection with a garden hose to help prime the unit before
attempting to connect to a siphon hose.
Before starting the motor:
„ Connect the garden hose (or the siphon hose when using
a non-pressurized water source).
NOTE: Make sure the pressure washer's water intake
screen is in place and unclogged before connecting.
„ Turn on the garden hose then pull the trigger to relieve air
pressure; hold the trigger until a steady stream of water
appears or submerge the siphon hose into the fresh
water source.
NOTE: Make sure the faucet is turned on fully and that
there are no kinks or leaks in the garden hose. If using the
siphon hose, make sure the filter is submerged completely
under the surface of the water.
To start the motor:
„ With the on/off switch in the off position ( O ), install the
battery pack(s) as previously described.
„ Put the on/off switch in the on position ( I ) to start the
motor.
Concrete, Brick, Masonry
Siding, Gutters, House
Fencing, Deck, Patio
Lawn Equipment, Boat, RV
OPERATION
NOZZLE SELECTION GUIDE
  Recommended Nozzle 
10 — English
To stop the motor:
„ Put the on/off switch in the off position (O).
„ Pull trigger to release water pressure.
NOTE: The pressure washer may be on and the system
may have pressure even when the pump and/or motor
cannot be heard running. Always use caution around the
pressure washer.
POWER SELECT BUTTON
See Figure 13.
Press the power select button to change the desired pres-
sure needed for the cleaning job.
When the unit starts, the pressure washer operates at 2,000
PSI and the LED will remain a solid green. Press the button
once to lower the unit to 1,500 PSI and the green LED will
blink rapidly. Press the select button a third time to lower
to 1,000 PSI and the green LED will blink slowly. Repeated
pressing of the button will repeat the cycles.
HIGH PRESSURE
(NO SOAP WHEN USING THESE NOZZLES)
Turbo Nozzle
 
Use With Caution for Certain Applications
LOW PRESSURE
(FOR SOAP OR
GENTLE RINSE)
Blue or Black
15º
Soap Nozzle
 
 

Publicidad

loading