Flex L 10-10 125 Instrucciones De Funcionamiento Originales página 21

L 10-10 125, L 810, L 1001
Attaching or changing the grinding
tool
Pull out the mains plug.

Press and hold down the spindle

lock (1.).
Using the face spanner, loosen the

clamping nut on the spindle in an anti-
clockwise direction and remove (2.).
Insert the grinding wheel in the correct

position.
Screw the clamping nut with flange face

up, onto the spindle.
Press and hold down the spindle lock.

Tighten the clamping nut with the face

spanner.
Insert the mains plug into the socket.

Switch on the angle grinder (without

locking into position) and leave the angle
grinder running for approx. 30 seconds.
Check for imbalances and vibrations.
Switch off the angle grinder.

Operating instructions
NOTE
When the power tool is switched off, the
grinding tool continues running briefly.
Rough-grinding
WARNING!
Never use cutting-off wheels for rough-
grinding.
– Angle of wheel 20–40° for best cutting
performance.
– Applying moderate pressure, move
the angle grinder backwards and
forwards. As a result, the workpiece will
not become too hot and there will be no
discoloration; nor will there be any
grooves.
Cut-off grinding
WARNING!
A special cutting guard must be used
for cut-off grinding.
– Do not press, tilt or oscillate the power
tool.
– Angle grinder must always operate in the
counter direction. Otherwise, there is
a risk of the angle grinder jumping
uncontrollably out of the groove.
– Adjust the feed to the material which is
to be work: the harder the material, the
slower the feed.
For further information on the manufacturer's
products go to www.flex-tools.com.
21