Publicidad
ASSEMBLY INSTRUCTIONS
Step 6
WARNING: Remove protective cover before assembling.
Note: If necessary for proper alignment of reflector
sections.
Attach 3 pcs reflector panels (A) to center reflector (B) using
9 pcs Screws M6x10 (II) and 9 pcs cap nuts (JJ).
Fully tighten all of the screws.
Hardware Used
7
Step
Attach 3 pcs reflector spacers (FF) and 3 pcs washers (GG)
to burner assembly (C) firstly. Tighten the reflector spacers.
Slide 3pcs washers (GG) over threaded end of spacer.
Attach the reflector assembly to the top of reflector spacer
(FF) using 3 pcs washers (GG) and 3 pcs wing nuts (KK).
Hardware Used
Reflector
FF
spacer
GG
Washer
KK
Wing nut
x 9
x 9
x 3
x 9
x 3
-12-
7-1
A
B
JJ
II
II
Publicidad
