Publicidad
Idiomas disponibles
Idiomas disponibles
users.
▶Maintain power tools. Check for misalignment or jammed moving
parts, breakages and any other condition that might affect the power
tools operation. If it is damaged, the power tool must be repaired.
Many accidents are caused by poorly maintained power tools.
▶Keep cutting tools sharp and clean. Properly maintained cutting
tools with sharp cutting edges are less likely to jam and are easier
to control.
▶Use the power tool, accessories and cutting tools etc. in accordance
with these instructions, taking into account the working conditions
and the work to be performed. Use of the power tool for operations
different from intended could result in a hazardous situation.
5) SERVICE
Your power tool shoul be serviced by a qualiified specialist using only
standard spare parts. This will ensure that it meets the required safety
standards
SAFETY INSTRUCTIONS FOR THE ELECTRIC
SOLDERING IRON
APPLICATION
▶A soldering iron is a hand tool most commonly used in soldering.
It supplies heat to melt the solder so that it can flow into the joint
between two workpieces.
▶Soldering irons are most often used for installation, repairs and
limited production work.
▶High-volume production lines use other soldering methods.
WARNING! For your own safety, read this manual and the
general safety instructions carefully before using the
appliance. Your power tool should only be given to other
users together with these instructions.
OPERATING INSTRUCTIONS
▶Before taking the tool into use, make sure of the following:
• Check the voltage given on the nameplate is the same as the
source of current
• Before heating up make sure the bit is properly in position, the
clamp screw must be tightened.
• Connect to appropriate main current.
• The bit can only be removed when the soldering iron is switched
off and without using force. Bit to be inserted till stop.
• Do not heat up soldering iron without bit.
• After use, let the soldering iron cool down in the air. (Do not cool
off in water).
• After use, put the iron only down on a holder
• The cable of the soldering irons is a special high quality cable.
It is resistant against short-time contact with hot metal parts.
Instruction manual
OPERATION
▶Connect the plug to an outlet.
▶Put the soldering iron on the stand, until soldering tip is well
▶Melt some soldering tin on the soldering tip.
▶Put the soldering tip to the point to be soldered.
▶Send some soldering tin to the point, until soldering tin melt.
▶Melt some tin to the other soldering part.
▶Solder the two parts together; avoid overheated, cool the soldering
In case of damage, the cable can not be exchanged due to the
special construction of the soldering iron. The iron can then no
longer be used according to the safety prescriptions.
heated.
point.
ref. 08386
ES
PT
EN
FR
Publicidad
