Cardin Elettronica ZVL544.03 Manual De Instrucciones página 17

SYSTEM MANAGEMENT OPERATIONS
• Memorizing a channel code
• Deleting a channel code (via an associated transmitter)
• Deleting the entire code memory (users)
• Memorizing more transmitters by using a previously memorized transmitters
Attention! Before memorising the transmitters for the first time remember to cancel the entire
memory content.
• Memorizing a channel code
- Move the transmitter near to the receiver.
- Press and hold down the P1 MEMO button on the receiver and the LED L1 will flash slowly
- Press the button (channel) you wish to memorize on the transmitter.
- The LED L1 on the receiver will flash rapidly.
- Press the button (channel) you wish to memorize on the transmitter a second time. The LED L1 on the
interface will glow continuously and the buzzer will sound twice. After a few moments led L1 will switch off.
- Release the P1 MEMO button. End of operation.
• Deleting a channel code (via an associated transmitter)
- Move the transmitter near to the receiver.
- Press and hold down the P2 DEL button on the receiver and the LED L1 will flash rapidly.
- Press the button (channel) you wish to delete on the transmitter.
- The LED L1 on the receiver will glow red continuously. After a few moments Led L1 will switch off.
- Release the P2 DEL button. End of operation.
• Deleting the entire code memory content (users)
- Press and hold down the P1 MEMO and P2 DEL buttons for more than 4 seconds on the interface.
- LED L1 will remain lit for the entire duration of the deletion, which lasts for about 3 seconds
- LED L1 will flash for a few moments and then switch off.
- Release the buttons. End of operation.
17