Philips AquaTrio Cordless 7000 Serie Manual Del Usuario página 12

English
12
Tips and other important information
Usage restrictions
-
It is not necessary to vacuum the floor before mopping, as the appliance
actively wet-cleans your hard floor to capture all kinds of dirt, including
liquids and stains.
-
You can move the appliance just like a vacuum cleaner. To remove difficult
stains, click the cleaning mode button to activate intense wet mode
move the appliance slowly over the stains.
-
The appliance can leave a small puddle of water on the floor when you switch
it off. You can reduce the size of the puddle by moving the appliance while
switching it off to reduce the amount of water left on the floor. It is also
recommended to use water absorption mode
over a threshold, carpet or stairs. This will prevent dirty water from dripping
out of the AquaSpin nozzle.
-
To prevent water traces on the floor, try to make less strong turns with your
appliance and avoid moving the appliance sideways.
-
When moving the appliance, it is recommended to stretch your arm to reduce
unnecessary tension on the muscles. In this position, you have the best
control over the appliance when cleaning, and it will be the most
comfortable.
-
The appliance is suitable for vacuuming and mopping all types of hard floors,
except uncoated wooden floors.
-
The appliance is intended for regular cleaning of hard floors. Always follow
the cleaning instructions for your hard floor when you use this appliance.
-
If you want to add a liquid floor cleaner other than XV1792 Philips Floor
Cleaner to the water in the clean water tank, make sure that you use a low-
foaming or non-foaming liquid floor cleaner that can be diluted in water like
XV1792 Philips Floor Cleaner.
-
As the clean water tank has a capacity of 700ml, you only have to add a small
amount (max 15ml) of liquid floor cleaner to the water.
-
If you use the appliance on linoleum floors, only do so on linoleum floors that
are properly affixed to prevent linoleum from being drawn into the AquaSpin
nozzle.
-
Do not use the appliance to clean carpets.
-
If you move/lift the appliance over a carpet or rug when it is switched off,
wastewater droplets may end up on your carpet or rug.
-
Do not push the appliance over the floor grilles of convector heaters. As the
appliance cannot pick up water that comes out of the nozzle when you move
it over the grille, water ends up at the bottom of the convector pit.
-
While cleaning, do not lift the AquaSpin nozzle from the floor or move the
AquaSpin nozzle sideways, and do not make strong turns, as this leaves water
traces.
Note: The operating time depends on the power level used during cleaning.
when lifting the appliance
and