Publicidad
Idiomas disponibles
Idiomas disponibles
1
YEAR
WARRANTY
1. BEFORE WELDING
Auto-Darkeing welding helmet is designed to protect the welders'eyes from harmful radiation including visible
light,ultraviolet radiation(UV)and infra-red radiation (IR)resulting from certain arc and gas welding processes when
used in accordance with these User instructions.
The Auto-Darkeing welding helmet comes assembled. However before it can be used , it must be adjusted to your
personal preferences. Set it up for delay time, sensitivity and shade number for your application.
WARNING
Make sure to remove any additional protection foil from both sides of protection Lens.
• Never place the helmet or the filter on hot surface.
• This Auto-Darkening welding helmet is not suitable for laser welding.
• Never open or tamper with the Auto-Darkening filter.
• This helmet will not protect against severe impact hazards.
• This helmet will not protect against explosive devices or corrosive liquids.
• Do not make any modifications to either the filter or helmet, unless specified in the manual.
• Do not use replacement parts other than those specified in this manual. Unauthorized modifications and
replacement parts will void the warranty and expose the operator to the risk of personal injury.
• Should this helmet not darken upon striking an arc, stop welding immediately and contact your supervisor or your
dealer.
• Do not immerse the filter in water.
• Do not use any solvents or abrasive cleaning detergent on the filter screen or helmet components.
• Use only at temperature :-5°Cto+55°C(23°F-131°F).
• Protect the filter from contact with liquid and dirt.
• The material which may come into contact with the wearer's skin can cause allergic reactions in some circumstances.
• The ADF shall only be used in conjunction with the inner cover lens.
• Eye-protectors against high speed particles worn over standard ophthalmic spectacles may transmit impacts, thus
crating a hazard to the wearer.
• Toughened mineral filter oculars shall only be used in conjunction with a suitable backing ocular.
• If the symbols For B are not common to both the ocular and the frame, the it is the lower level which shall be
assigned to the complete eye-protection.
• Material aging is comment state after long time using, like burst damage. This product will not be able to have
effective protection after this happened, user have to immediately stop using it.
• This product cannot be used for over-head position welding or look up cutting welding. If this product is used for over
head welding or look up cutting operation, the molten metal drop may burn though helmet and welder will get
injured.
• If protection against high speed particles at extremes of temperature is required then the selected eye-protector
should be marked with the letter T immediately after the impact letter, i.e. FT, BT or AT. If the impact letter is not
followed by the letter T then the eye protector shall only be used against high speed particles at room temperature.
• This product has certain heat resistant and flame retardant, but in case of open flame or access to high temperature
subject, mask may burn or melting. Please properly store and use in order to reduce such risks.
2
Publicidad
