Publicidad
Idiomas disponibles
Idiomas disponibles
1
YEAR
WARRANTY
4-4. Angle Adjustment(See adjustment "X" in Fig.4)
Four pins on the right side of the headgear top provide adjustment for the forward tilt of the helmet. To adjust,loosen
the right outside tension adjustment knob then lift on the control arm tab and move it to the desired position and
retighten tension adjustment knob.
NOTE: Make sure both sides are equally positioned for proper operation
5. AUTO-DARKENING FILTER FUNCTION
5-1. Selecting the Operating Mode
For some filters, two modes of operation can be selected: welding or grinding. (See Fig.3)
Grind Mode-Used for metal grinding applications. In this mode the shade function is turned off. The shade is fixed in
the light state that all-owing a clear view to grind a weld with the helmet providing face protection.
Grind mode is intended for grinding not for welding. Before restarting welding,the knob should be set back to the
"Weld" position.
5-2. Selecting Shade Level
Most of models enable shade adjustment range from shade 9-13 Some selected models have two shade ranges,i.e.
shade 5-8 and 9-13. The adjustment of the"5-8 /9-13 range knob" defines the range which is being used( See Fig.5).
Select the shade number to match the welding process procedures. You have variable adjustments between shade
numbers 5-8 and 9-13 available in the darkened state. The shade number can be selected by turning the adjustment
knob on the side of the helmet; the arrow on the switch indicates the shade setting.
5-3. Selecting Delay Time
The Delay Time knib will vary from dark to light time,it can be set at "MAX" (1.0 second) or "MIN" (0.1 second) by using
the infinitely dial knob. See Fig.6)
"MAX" (1.0 second)-Longer delay is for most welding applications,specially for high amperage (current) applications;
"MIN" (0.1 second)-Shorter delay is for Spot welding applications
5
Publicidad
