Publicidad
Idiomas disponibles
Idiomas disponibles
4. FITTING THE MAIN POST.-
Once the bottom post cover, is fitted,
bring the main post (25) up to boss on
the main body (99), Fig.6.
Plug connector (116), coming out of
the main post (25), into connector
(119), coming out of the boss on the
main body (99).
Slip the main post (25) over the boss
(99) on the main body in the direction
of the arrow, Fig.6, making sure not to
snag any of the cables.
Fit the screws (150) and (151), along
with the washers (152) and nuts (93),
Fig.6, and tighten securely.
Lower the bottom trim section (29) for
the main post (25) down over the boss
section of the main body (99).
5.- FITTING THE FOCUS BARS.-
Insert the flat washers (14,136) and
the left focus bar (8L) (marked with the
letter "L") onto the focus bar spindle
(25), Fig.7, then fit the right focus bar
(8R) (marked with the letter "R") on
the other end of the spindle. Fit the
washered bolts (20) and the flat
washers (18-19) and with the help of
the box spanners tighten securely.
Connect the terminals (118) and (117),
Fig.7A.
6.- MOUNTING THE FOOT ARMS.-
Take the left foot arm (33L) (marked
with the letter L) and insert it in the left
upper arm (8L) ensuring that the letters
coincide (L), Fig.8 insert screws (22)
and the flat washers (19-21) and tighten.
Follow the same procedure for the
right foot arm (33R).
7.- FITTING THE FEET.-
Take the left foot tube (131), insert the
washer (129) and align the holes on
the two tubes on the inside of tube
(33L) in the direction of the arrow,
Fig.8.
Next, take the knob (132) and screw it
clockwise onto tube (33L) Fig.8.
Then take the right foot tube (131) and
insert the tube into tube (33R) in the
direction of the arrow, Fig.8.
Next, take the knob (132) and by
aligning the holes on the two tubes
screw it clockwise onto tube (33R) Fig.8.
Take the right pedal (42R), Fig.9,
(marked with the setter "R") and slide
it onto the crank shaft (81R) on the
right- hand side of the machine.
Now take washers (32) and (39) and
bolt (20) and tighten securely.
Finally, fit the caps (38).
Take the left pedal (42L), Fig.9,
(marked with the setter "L") and slide it
onto the shaft (70L) on the left-hand
side of the machine.
Now take washer (19) and (39) and
bolt (20) and tighten securely.
Finally, fit the caps (38).
Take the right foot (42R) and position
it in the "U" of the lower right arm (8R)
Fig.9, insert screw (34) as shown in
Fig 9 and take flat washer (32) and
self-locking nut (31) and tighten firmly.
Take the left foot (42L), and position it
in the "U" of the lower left arm (8L)
Fig.9, insert screw (34) as shown in
Fig.9 and take flat washer (32) and
self-locking nut (31) and tighten firmly.
8. FOCUS BAR SETTINGS.-
To adjust the angle of the feet for doing
exercise and the length of the focus bar
swing, turn knob (132) anticlockwise to
loosen it slightly, hold the foot and pull
the knob outward Fig.8.
16
Publicidad
