Bosch GWS Professional 15-125 CIEH Manual Original página 32

OBJ_BUCH-165-005.book Page 33 Wednesday, July 28, 2010 8:54 AM
Cutting Stone
Provide for sufficient dust extraction when
cutting stone.
Wear a dust respirator.
The machine may be used only for dry cut-
ting/grinding.
For cutting stone, it is best to use a diamond
cutting disc.
When using the cutting guide with dust extrac-
tion protection guard 21, the vacuum cleaner
must be approved for vacuuming masonry dust.
Suitable vacuum cleaners are available from
Bosch.
For cutting expecially hard material, e. g., con-
crete with high pebble content, the diamond
cutting disc can overheat and become damaged
as a result. This is clearly indicated by circular
sparking, rotating with the diamond cutting
disc.
In this case, interrupt the cutting process and al-
low the diamond cutting disc to cool by running
the machine for a short time at maximum speed
with no load.
Noticeable decreasing work progress and circu-
lar sparking are indications of a diamond cutting
disc that has become dull. Briefly cutting into
abrasive material (e. g. lime-sand brick) can re-
sharpen the disc again.
Information on Structures
Slots in structural walls are subject to the
Standard DIN 1053 Part 1, or country-specific
regulations.
These regulations are to be observed under all
circumstances. Before beginning work, consult
the responsible structural engineer, architect or
the construction supervisor.
Bosch Power Tools
Maintenance and Service
Maintenance and Cleaning
Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and ventilation slots clean.
In extreme conditions, always use dust ex-
traction as far as possible. Blow out ventila-
tion slots frequently and install a residual
current device (RCD). When working metals,
conductive dust can settle in the interior of
the power tool. The total insulation of the
power tool can be impaired.
Switch on the ma-
Please store and handle the accessory(-ies)
chine and place
carefully.
the front part of
If the machine should fail despite the care taken
the cutting guide
in manufacturing and testing procedures, repair
on the workpiece.
should be carried out by an after-sales service
Slide the machine
centre for Bosch power tools.
with moderate
feed, adapted to
In all correspondence and spare parts order,
the material to be
please always include the 10-digit article
worked.
number given on the type plate of the machine.
After-sales Service and Customer
Assistance
Our after-sales service responds to your ques-
tions concerning maintenance and repair of your
product as well as spare parts. Exploded views
and information on spare parts can also be
found under:
www.bosch-pt.com
Our customer service representatives can an-
swer your questions concerning possible appli-
cations and adjustment of products and acces-
sories.
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham
Uxbridge
UB 9 5HJ
Tel. Service: +44 (0844) 736 0109
Fax: +44 (0844) 736 0146
E-Mail: boschservicecentre@bosch.com
English | 33
1 609 929 X20 | (28.7.10)