Adjust The Chain Tension; Add The Bar And Chain Lubricant - GreenWorks 1403402 Manual Del Operador

EN
4. Put the chain cutters (21) in the direction of the
chain operation.
5. Put the chain in position and make sure that the
loop is behind the guide bar.
6. Hold the chain and bar.
7. Put the chain loop around the sprocket (17).
8. Make sure the chain tension pin hole (19) on the
guide bar fits correctly with the bolt (18).
9. Install the chain cover.
10. Tighten the chain. Refer to
11. Tighten the chain cover knob when the chain is
correctly tensioned.
If you start the chain saw with a new chain, have a test
for 2-3 minutes. A new chain gets longer after the first
use, examine the tension and tighten the chain if
necessary.

16.2 ADJUST THE CHAIN TENSION

Wear protective gloves if you touch the chain, bar or
areas around the chain.
1. Loosen the chain cover by turning the chain cover
knob counterclockwise.
21
20
22
18 19
17
Adjust the chain tension.
NOTE
CAUTION
English
It is not necessary to remove the chain cover to adjust
the chain tension.
2. Turn the chain tension screw (41) behind the bar
and chain clockwise to increase the chain tension.
3. Turn the chain tension screw counterclockwise to
decrease the chain tension.
4. When the chain is at the desired tension, tighten the
chain cover.
16.3 ADD THE BAR AND CHAIN
LUBRICANT
Examine the amount of oil in the machine. If the oil level
is low, add the bar and chain lubricant as follows.
Use bar and chain lubricant that is only for chains and
chain oilers.
The machine comes from the factory without bar and
chain lubricant.
1. Loosen and remove the cap (40) from the oil tank.
2. Put the oil into the oil tank.
3. Monitor the oil indicator to make sure that no dirt
gets into the oil tank while you add the oil.
4. Put the oil cap on.
5. Tighten the oil cap.
14
NOTE
IMPORTANT
NOTE
40
41